Central Reporting Job Scheduling
CR2xxxJ CR5xxxJ CR6xxxJ CR7xxxJ PG8xxx PG9xxx Other

CR6040J
Salary Forecasting - Reporting Extract

This job builds a reporting extract file of salary forecasting information from the SF data base from which cost factors are applied against and reports are produced from.
Special Instructions None
Frequency On-request
Scheduling Restrictions None
Execution Time Anytime (O, B, P or I)
Job Completion Status None
Job Groups
PG614R     SF - SBCCE Reporting Extract
Job Dependency CR6020J, CR6030J and CR6025J should have been run prior to this job.
Operator Instructions None
Estimated Run Time None
Recovery/Restart This job is restartable.


Parameters

CR6040-JOB-FUNC Enter from 1 to 15 specific job function codes (separated by a comma) to be selected. (I.e., xx,xx,etc.) If left blank, all job functions are selected. See attached list.
CR6040-PERM-TEMP Enter "P" if only permanent employees are to be selected or "T" if only temporary employees are to be selected. If left blank, both permanent and temporary employees are selected.
FYR The fiscal year of the SF data base data to be extracted. Enter as YYYY.
SF-OUTPUT Enter up to a 6 digit file identification of the output reporting extract file to be created. This file identification will be used to control the input and output file generation iterations used in the factoring increase process and will be identified on all the salary forecasting reports as to the source of the data. It is suggested that the fiscal year being reported followed by the letter "A", (i.e., 8889A) be used where the letter "A" will signify the initial or "BASE" reporting extract file generated from the SF data base.

Distribution: PPMS
Created: WED, JAN 04, 2012, 06:54 AM